Sunday, October 7, 2012

WhiteAnt 3d Printer Build- Full Height Test Print



I created a cylinder in Google SketchUp that is 145mm tall and 40mm wide for this test.










Critique:
Overall the the print is fine. 

Posted by at
Labels: , ,
Location: Richmond, VA, USA

2 comments:

  1. AnonymousAugust 30, 2013 at 9:35 PM

    Hello, love your blog been very informal on building my white ant. my question is did you leave the hight for the z axis rail the same or did you alter the hight? thanks steve hall. nevets0@yahoo.com

    ReplyDelete
  2. RSAugust 31, 2013 at 6:11 AM

    Steve. I left the height the same. I don't think I would go much higher because of stability issues. The Z carriage system as a whole is very heavy. Overall, if I was to do it again, I'm not sure if I would increase the build volume much more.

    ReplyDelete

Subscribe to: Post Comments (Atom)